您好，欢迎访问江苏省农业科学院 机构知识库！
江苏省农业科学院机构知识库

全部

  • 全部
  • 标题
  • 学者
  • 机构
  • 关键词

Rationally Regulating the Mechanical Performance of Porous PDMS Coatings for the Enhanced Icephobicity toward Large-Scale Ice

文献类型： 外文期刊

作者： Zeng, Chaojiao 1 ; Shen, Yizhou 1 ; Tao, Jie 1 ; Chen, Haifeng 2 ; Wang, Zhe 1 ; Liu, Senyun 3 ; Lu, Daipeng 4 ; Xie, Xinyu 1 ;

作者机构： 1.Nanjing Univ Aeronaut & Astronaut, Coll Mat Sci & Technol, Nanjing 210016, Peoples R China

2.Huzhou Univ, Qiuzhen Sch, Dept Mat Chem, Huzhou 313000, Peoples R China

3.China Aerodynam Res & Dev Ctr, Key Lab Icing & Anti Deicing, Mianyang 621000, Sichuan, Peoples R China

4.Jiangsu Acad Agr Sci, Inst Agr Facil & Equipment, Nanjing 210014, Jiangsu, Peoples R China

期刊名称：LANGMUIR （ 影响因子：4.331； 五年影响因子：4.209 ）

ISSN： 0743-7463

年卷期： 2022 年 38 卷 3 期

页码：

收录情况： SCI

摘要： Ice accumulation on various surfaces in low-temperature and high-humidity environments is still a major challenge for several engineering applications. Herein, we fabricated a kind of PDMS coating with the introduction of porous structures under the surface by a two-step curing and phase separation method. The coatings with no further surface modification showed good hydrophobicity and icephobicity, and the typical ice adhesion strength was down to 40 kPa with a water contact angle of 116.5 degrees. More than that, the porous PDMS coatings showed extraordinary icephobicity, especially toward large-scale ice (>10 cm(2)). In this case, the large-scale ice layer can be rapidly removed under a small external deicing force in a form of interface crack propagation rather than whole direct fracture. It was confirmed that by regulating the pore size and porosity of PDMS coatings properly, the stiffness mismatch between coatings and ice can be controlled to induce the initiation of interfacial cracks. On this basis, under the condition of a large-scale icing area, a small external deicing force can cause an increased surface stress concentration, and the formed interface cracks can propagate quickly, resulting in the ice layer falling off easily. In addition, under the influence of the size effect, ice can be removed without an additional force, and the minimum external force (per unit width) can be only 60 N/cm. This paper proposes that prefabricating a large number of microcracks at the interface can significantly weaken the bonding between ice and coatings, that is, reduce the fracture toughness. The new coatings have a remarkable effect toward large-scale icing.

  • 相关文献
作者其他论文 更多>>
置顶
购物车
反馈

© 京ICP备09089781号-29 主办单位：江苏省农业科学院

学术资源： 中国农业科学院 农业专业知识服务系统 农科联盟资源共建共享平台 中国农业科技文献与信息服务平台 中国农业期刊集成服务平台